anyone make an outlet pipe for this turbo?
 

this is a garrett t3 off of an older svo, turbocoupe, and merkur xr4ti.
https://i4.photobucket.com/albums/y1...cchmbr/svo.jpg

i have an inlet/intake pipe for it, but i need something to go into the compressor outlet 2-bolt flange. my friend made something up for me out of an extra tial wastegate flange, but it doesn't seal all of the way.

Re: anyone make an outlet pipe for this turbo?
 

the factory cars had cast elbows with that flange on them...look on ebay for them

Re: anyone make an outlet pipe for this turbo?
 

i have been looking for them, but cant find any. i was looking for a custom made one thats on maybe a 90* angle or something. i saw some on ebay a while a go that were 90* angles and sloped from factory size to 2.5"...but they aren't around anymore.

Re: anyone make an outlet pipe for this turbo?
 

Check out this thread, guy was in the same situation as you.

https://www.homemadeturbo.com/forum/...?topic=56342.0

And here's a picture of what you need. Unfortunately they are both sold but this may help you in your search. The top-left or top-middle compressor outlets in the picture will both fit your turbo.

http://cgi.ebay.com/ebaymotors/T3-Tu...spagenameZWDVW

Re: anyone make an outlet pipe for this turbo?
 

the eom ones wont work for my setup due to the angle...looking for an aftermarket one

Re: anyone make an outlet pipe for this turbo?
 

so then just buy one that will fit and cut it off an inch or so from the flange and then just fab something to go the rout you want to.

Re: anyone make an outlet pipe for this turbo?
 

Go buy a flange at an exhaust shop for $2.00.

Re: anyone make an outlet pipe for this turbo?
 

weld a pipe on the compressor housing :P