Anyone has this setup?
#1
Anyone has this setup?
D16z6 stock block with stock p28 ecu
rhb5 turbo from a mx-6 2.2l ( or a probe)
Hf manifold port matched
dsm 450cc
1gen dsm bov
dsm smic
stock fuel pump
custom piping
well... anyone has this setup or something similar?
I want to know, what kind of fuel management you are using and how much psi you run...that would help me a lot.
If someone is using uberdata with this setup... could someone be able to burn a chip to "control" this kit?
rhb5 turbo from a mx-6 2.2l ( or a probe)
Hf manifold port matched
dsm 450cc
1gen dsm bov
dsm smic
stock fuel pump
custom piping
well... anyone has this setup or something similar?
I want to know, what kind of fuel management you are using and how much psi you run...that would help me a lot.
If someone is using uberdata with this setup... could someone be able to burn a chip to "control" this kit?
#5
Re:Anyone has this setup?
if u can get a hold of troyb hes could help u
hes running turboedit but its almost the same
man i would kill for a 50 right now
hes running turboedit but its almost the same
man i would kill for a 50 right now
I dont know well turboedit... can it be run on a p28 ecu?
#7
Re:Anyone has this setup?
SOrry for the delay, I'm in Kitchener/London/Exeter/Grand Bend Area. I can do a P28. I'm tuning my bud b16 with it. Depending on were you are. I don't like to desolder any chips but I can if you want my to. I can get it done for 20 bucks at a shop and I can do all the resistors. Wait I don't have to Desolier a P28 Right? Anyways let me know If you need help!
#9
Re:Anyone has this setup?
Originally Posted by Civ_Hatch91
im going to be running the same setup except with a chipped pr4 ecu to control, does anyone know where i can get a turbo edit map that will work with ng26 for this setup?
-ryan
Thread
Thread Starter
Forum
Replies
Last Post
HMTguy
General Discussion
8
11-14-2005 07:48 PM
Semnos
General Discussion
13
08-15-2005 04:04 PM
brax90si
Forced Induction
4
01-29-2003 06:13 PM