sohcrxsi

Anyone using this? It seems like it could work pretty well as far as disapating heat. If I could find some mandrel bends I could just cut and braze as needed. I could even get a bunch of cheap intakes off ebay and use them. It would be a little more expensive than steel but I think the bling factor would more than make up for it. Plus, there might even be some additional performance. Any input?

Paperchase013

walls kind of thin, but it should work.

d16forlife

disepate heat?Aluminum is a really good heat conductor.It will not disepate heat.It will draw heat.If your running an intercooler the acool aluminum will draw the under hood heat.

I would stick to good old 16 guage steel.It seems to keep cooler IMO

sohcrxsi

i thought that it would disapate heat, like when you heat it up with a torch it cools faster that steel

accordepicenter

That is true but figure this, itll also suffer from heat soak from the engine and everything else (turbo... wink wink) thats in the engine bay. If you need serious bling factor go stainless, shines better, doesnt conduct heat as well as mild steel, and even mild steel doesnt conduct heat nearly as well as aluminum. Plus fitting charge pipes is easier with stainless because its easier to weld than aluminum...

Paperchase013

it may cooler faster, but that means that it heats up quicker.


so it would take alot less time for it to get hot and stay hot than mild steel would, but then when u turn of the car it will cool quicker.

now, which is more important

91civicZ6

a couple of pieces of my ghetto *** charge pipe setup are from old cold air intakes. works fine.

sohcrxsi

i guess i'll just go with mild steel and hit it with some mexican chrome for the bling i thought it would look pretty nice if it came out well, plus it would give me a chance to show off my brazing. sometimes when i bored i cut soda cans in half and braze them back together :P

quadnie

I try and weld beer cans to ---- all the time.. it rarely works. The other thing I do is try and get the fire in the burn pit hot enough so it melts the beer cans.

sohcrxsi

it is pretty difficult to do. its tricky to get the can hot enough, but not too hot. i actually had some really old guy teach me how a while back. i'll try to post some pics when i get a chance.