i'm interested in water/alcohol injection on the motor i'm building this spring... i know i few of you guys run this. if so can you school me on the parts you bought. and about how much it cost ya. cuz i don't know if i want to spend 300 beans for a kit

 

I have an aquamist alchy injection kit. they have a few diff. kits avalible. Im sure it wouldn't be too hard to make your own. all your really gonna need is a pump, reseviour,line,nitrous spray nozzle, and a pressure switch

 

check eGay

 

you could have it pressurized by compressed air, sort of like how a fire extinguisher works. have the boost switch make a servo open a valve to release air pressure in to the chamber of where the alcohole is and that would in turn drive the liquid through a line in to the nozzle and create so much pressure that you'd get a nice mist, I dont know what kind of pump would make enough pressure this.

 

I got my pump from northern tool, the nozzle from mcmaster, used my windshield washer tank, and just misc lines and fittings from the hardware store. it's not all hooked up yet, I don' thave any of the elctronics routed right now, I built a little boost activated controller, but I haven't set it up yet.

 

cool...i'm for sure going to rig up for water/alchy..i'm planning i built z6 , filled , forged pistons, scat rods, arps, etc. i was hoping with the water/alchy i could push 18psi on a good day