I just got my greddy profec type S EBC, and installed it last night. Today I went driving, trying to get back up to 12psi, which I was running with my MBC, using the "low boost" setting,but its maxing out at 9 psi or so. My internal wastegate actuator is set at about 5-6 psi.

Should I set my internal wastegate to a higher boost setting?

Is the "low boost" limited as compared to the" high boost" setting, meaning will the same numeric setting on the high boost side run higher than the low boost side?


Thanks

 

You need to raise your Gain setting and the percentage over stock setting. Then when you get in the range use the gain setting to tune out any spike.

 

the thing is that I have the "low boost" setting maxed out, and am only getting about 9 psi. Gain is one click shy of spiking.

 

you know what is wierd? the way the instruction manual sometimes has info in it that explains how the thing works...

Yeah, in the manual it say that the lowest "high boost" setting is equal to just shy of the highest "low boost" setting.