zestyskater69

Well i picked up an ebay blow off valve for my junk yard set up, ya i know. http://cgi.ebay.com/ebaymotors/Turbo...ayphotohosting

Now i welded on the flange and got my kit together but it just doesnt open/sound? I cut off 2 rings off the spring and still nothing? do i adjust the nut on top? it came with some washers, what for? i need to get this ---- bov to open! thanks for any input!

Donald125

Does it work if ur hitting full boost or just not blowing off on neutral rev.

You can stack the washers with the spring to run the bov at higher boost

zestyskater69

Neither, so you would open up the bov and just put them on top of the spring? hmmm, sounds kind of sketchy to me?

robs99si

if the bov isn't openning up after full boost then you're gonna have to cut a coil or two off the spring so it can soften up some and open up easier. also have it hooked upto a strong vacume source like the pcv valve.

SpankedYA!

I have the greddy knock off and I had to remove one of the springs inside and adjust the top stud to get it to work.

zestyskater69

CSaddict thats exactly what i was thinking, adjusting the top stud. I will do it when i get out of work. how does yours sound?

zestyskater69

Well i tried to adjust the nipple on top of the bov and still nothing?

robs99si

didn't you read my post cut off one coil off the spring, this should solve the problem. if it doesn't then cut off another coil or half of a coil. becareful running the car with the bov top loose, i did that and the top came loose and the bov piston flew onto the road, never to be seen again.

Donald125

the nipple on top of that one specific bov does nothing, if you twist open the cap there are NOTHING can adjusted.
you have to trust me

zestyskater69

If you read my first post i already cut off 2 coils and nothing happened?