9.5:1 Slugs + .040 Milling = Shit on 94 pump?
I found a great deal on a set of used SRP 9.5:1 slugs, but really need some help/advise on whether or not to get them.
My head was built and I asked for .040 to be taken off because at first I planned on stock compression and that would knock it up quite a bit Now 9.5:1 and the milling would work me to about 10.2:1 or so correct? Anyway I could double stack an A6 gasket to drop it down a little? t3 .60/.63, 16psi, 94 octane, budget fully built A6, daily driven on turboedit Thanks!! |
Re:9.5:1 Slugs + .040 Milling = Shit on 94 pump?
Tune the ---- outta it and run the highest octane you can.
|
Re:9.5:1 Slugs + .040 Milling = Shit on 94 pump?
my stock b16 is 10.2:1 c/r and it loved 15 psi with stock internals on 93 oct., you'll be fine ;)
|
Re:9.5:1 Slugs + .040 Milling = Shit on 94 pump?
anything over 15-16 psi you will start o detonate, be careful. Do you have an exhuast temp guage? This wuold help monitor your ex. temps
|
Re:9.5:1 Slugs + .040 Milling = Shit on 94 pump?
Originally Posted by hong lo
anything over 15-16 psi you will start o detonate, be careful. Do you have an exhuast temp guage? This wuold help monitor your ex. temps
|
Re:9.5:1 Slugs + .040 Milling = Shit on 94 pump?
.040, your cam timing will be off a bit you should probably use a cam gear to get it back in check if your going to hit a dyno ;)
|
Re:9.5:1 Slugs + .040 Milling = Shit on 94 pump?
Ive got an AEM adjustable cam gear, no biggie there
So you guys think pump would be able to hold this sucker without pulling loads of timing? I figured the compression would be to high |
Re:9.5:1 Slugs + .040 Milling = Shit on 94 pump?
yeah, like i said, usdm b16's are 10.2:1 and b18c's are higher. people (including me) boost them every day on pump gas. teh fact that you have forged internals makes it all that much safer/stronger.
|
Re:9.5:1 Slugs + .040 Milling = Shit on 94 pump?
Yeah I was just being sure it wasnt balls high for a d16
Anyways, have any info on double stacking a headgasket? Never heard if it could be done Dont wanna really fork out $100 for a cosmetic becuase Im sure I may blow them a fair bit Thanks for the help |
Re:9.5:1 Slugs + .040 Milling = Shit on 94 pump?
9.5:1 SRP's w/ a .040 milled head = 10.4:1. :)
|
All times are GMT -5. The time now is 02:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands