2 Quick question's
Ok i have a tial 38mm w/g and i just want to make sure that the back line goes to a boost source/compressor housing and the top is left open correct?
I also have a greddy type s bov and the bottom line is left alone and the top goes to boost/vac source? |
Re: 2 Quick question's
:y double checking never hurts.. you are correct
|
Re: 2 Quick question's
I'll double that O0
|
Re: 2 Quick question's
Thanx guys im installing tomorrow so i just wanted to make sure but now i got another question, on a vortech FMU the fuel return is out of the bottom and the in is on the side right
|
Re: 2 Quick question's
Nevermind i just found a diagram and its right
Thanx ill post some pix soon |
Re: 2 Quick question's
[quote=turbocivic6776 ]
Ok i have a tial 38mm w/g and i just want to make sure that the back line goes to a boost source/compressor housing ok kinda unsure on this but if you put it on the compressor housing will it read differnet(open sooner or later) than putting it on the mani. flame me if needed |
Re: 2 Quick question's
Well the compressor housing will make the w/g open sooner and run a small amount less boost to your engine since there is usually a pressure drop beteeen the compressor and intake manifold therfore if you had your w/g set to the intake manifold it would allow the exact amount of boost that your w/g is set at before it opens.
|
Re: 2 Quick question's
thanks for clearing that up
|
All times are GMT -5. The time now is 12:29 PM. |
© 2024 MH Sub I, LLC dba Internet Brands