---- wont fit...
#1
---- wont fit...
i have a crx with a zc and i got a ss manifold and welded on a 14b footprint i have the orignal wastegate/downpipe flange on it i just went ot go mount the turbo manifold and all on and the ------- studs on my down pipe flange are hiting my front cross member...what the hell can i do about it if you need pics let me know...i relly need some serious help if it isnt one thing its another stoppin me from finishing this project
#4
Re: ---- wont fit...
Originally Posted by slo_crx1
...I took the cross member off the car, welded angled stock to it to hold it in it's original shape, then cut out the center where I needed clearance for the header and radiator. Then I made a triangulated tubular filler piece out of 1.25" thick walled tubing with 1/4" flat stock welded to the sides of the original crossmember pieces. The smaller tubing going across are for structural support to the triangulated pieces. It's worked really well so far, been driving on it that way since I went back to all-slower lol. No stress cracks or stress points and takes a launch very well with the Energy Suspension poly radius rod bushings.
#5
Re: ---- wont fit...
yah i just didnt want to weaken the front up to much cuz i notuiced the front motor mount is on that bitch and i wasent sure ....if i should cut off a few inches of the including the flange ...and weld a pipe off of that ....i dont know i was just trying to get some ideas befor i made a decision
Thread
Thread Starter
Forum
Replies
Last Post
just2spool
Forced Induction
2
02-27-2006 07:30 PM
W O T
General Discussion
23
12-10-2005 05:16 PM
robs99si
Forced Induction
0
05-13-2003 09:02 PM