^^ ditto

eBay, of all places. I had to do some looking around, but found it here:
Aluminum Boost Controller Pressure Adjust Kit Mechanica:eBay Motors (item 310149195845 end time Jul-16-09 11:22:25 PDT)

from the seller:
eBay My World - zerotek_motorsports

My one and only complaint about it is that it uses philips heads to hold it together. It came with some high-quality allen heads for mounting, though. Oh, and the sticker on the front was terrible too. That came off pretty easily, though.

haha same!

I was wondering where did this thread has gone hehe.

nice job on your cuts. i use a jigsaw or a sawzall to do my cutting. i never really liked using a cutoff wheel.

Oh man, I had kinda forgotten about HMT. I haven't been visiting forums in awhile, but there has been some serious fab work going on since this. Seat brackets, subframe connectors, and lower control arms, and now I'm working on a differential mount since my stock mount sucks big floppy donkey ... tongue.

Considering making a header, but I can't find low prices for 1.75" (or so) mandrel bends. They're expensive!

late reply here. i buy all my piping here

Tube Bending & Fabrication - Columbia River Mandrel Bending

i haven't seen any mandrel bends for a lower price.

I've put that project on hold and found a BMW e36 coupe in my hands, so that's been getting a lot of attention. There are tons of plans in the works, but for right now I'm strictly focused on taking care of the minimum mechanical maintenance required for it.