my less 10min test pipe "mig'ed"
 

i had not enought time to do this because my boost had to go out today , only had like 15min and made this in like 8-9 min..

:6

http://img296.imageshack.us/img296/5...74copiahi7.jpg

http://img139.imageshack.us/img139/4...72copialy5.jpg

ill make soon my log mani mig welded, just looking order flanges to Weir tech this days!

Re: my less 10min test pipe "mig'ed"
 

Good stuff Walter. Can't wait to see the manifold.

Re: my less 10min test pipe "mig'ed"
 

thx! ill take enough time to make that mani..btw what do u use for WG port?

something like this or what?

http://www.almacenesarenal.com/image...ogo/54.411.jpg

Re: my less 10min test pipe "mig'ed"
 

hole saws and toches work well. torches are alot easier and faster, but you use what ya got!

Re: my less 10min test pipe "mig'ed"
 

and it's better to spend the $15-20 on a good holesaw, use it once and sell it to somebody else for $10-15 than it is buy a cheap one that'll cut a handful of holes. (cutting fluid owns)

Re: my less 10min test pipe "mig'ed"
 

I prefer the holesaw to the plasma cutter for wastegate holes.

Re: my less 10min test pipe "mig'ed"
 

A tip for noobie using hole saw's....if you think you are going to slow, go slower!

Re: my less 10min test pipe "mig'ed"
 

good advice

Re: my less 10min test pipe "mig'ed"
 

looks good Walter. :6

Re: my less 10min test pipe "mig'ed"
 

looks pretty good but remember to always aim for the thicker material, and go just a bit slower

Re: my less 10min test pipe "mig'ed"
 

Turn your voltage up, your wire down, Slow down and like racin tweek said concentrate heat on the thicker metal.... I just got done making some exhaust for a buddy, this is what your aiming for(minus the spatter...)
Attachment 19004

Re: my less 10min test pipe "mig'ed"
 

hehe dont worry will take more time to weld better , like i said above, i had not enought time to weld very well :-\

ur welds looks good!

Re: my less 10min test pipe "mig'ed"
 

They should I weld 50 hours a weak :P just not on stuff this thin, or with a welder this small