Large Oil Drain Flange Help
1 Attachment(s)
I'm having trouble finding an oil drain flange large enough to fit my turbo. I don't know what type of turbo it is, other than it's a Garrett and I have a Detroit Diesel part number. (Pic is below) The flange dimensions are as follows. The drain hole is just over an inch in diameter and the mount bolt spacing is approximately 2.1 inches center to center. Any ideas where I could get something that would work? I've googled and yahooed and can't find anything. I think I might be able to find some half inch thick piece of aluminum and just drill it out to work.
Attachment 5542 |
|
Originally Posted by busa4
(Post 1302106)
|
just out of curiosity, what turbine inlet does it have? Where did you get that beast?
|
2 Attachment(s)
Originally Posted by josh19wrc
(Post 1302130)
just out of curiosity, what turbine inlet does it have? Where did you get that beast?
http://i104.photobucket.com/albums/m...to/Exhaust.jpg Attachment 5540 Here's the truck that it's in. It's a 1990 Chevy Silverado. Attachment 5541 |
i have a 1/2 npt drain flange that measure 2.00 center bolt to center bolt. (measured with a dial caliper.)
|
Originally Posted by busa4
(Post 1302138)
i have a 1/2 npt drain flange that measure 2.00 center bolt to center bolt. (measured with a dial caliper.)
|
Here's a picture. It's 2.1"/53mm center to center. All the drain flanges I've seen are 2.0"/50.8mm center to center.
http://i104.photobucket.com/albums/m...TruboDrain.jpg |
you may have to make it or buy it from the mfg of the turbo or the mfg of the engine it came from.
|
NICE RIG MAN!
|
All times are GMT -5. The time now is 01:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands