Home depot Sinklog mani
#1
Home depot Sinklog mani
Never did use this, cost like 10 bucks and maby someone will find it helpful.
1 1/4" Black iron elbows x4
Eye it out and grind away
Weld inside and out. no pre-heat nessesary as they are actualy low grade mild and not iron.
bang a 2.5" pipe into an oval and eye out the cut to make it fit into the elbows. i used a bench grinder
Weld that ---- up
Weld on 2 more elbows, followed by the flange cut off our stock exhaust. i also removed the inner pipe and ported it out.
cut you your desiered lenght or run it off the the side, then slap on a turbo flange.
1 1/4" Black iron elbows x4
Eye it out and grind away
Weld inside and out. no pre-heat nessesary as they are actualy low grade mild and not iron.
bang a 2.5" pipe into an oval and eye out the cut to make it fit into the elbows. i used a bench grinder
Weld that ---- up
Weld on 2 more elbows, followed by the flange cut off our stock exhaust. i also removed the inner pipe and ported it out.
cut you your desiered lenght or run it off the the side, then slap on a turbo flange.