ZT-2 Datalogging and Uberdata help
I got my wideband connected to a 12v source and I read the AFR values throught Zeitronix's software. My only problem is that I need to connect the RPM line to the ECU and the outputs to Uberdata. The Uberdata forums are down and I cannot find the information I need to connect them to the ECU. (i.e. the specific wires on the ECU)
Any help is greatly appreciated. :D |
Re: ZT-2 Datalogging and Uberdata help
i would imagine u could hook it up to the tach wire that comes right off the distributor. well if you pull out your gauge cluster its the solid blue wire
|
Re: ZT-2 Datalogging and Uberdata help
I just researched this. You want go to go here. http://plxdevices.com/ECUDatabase/Ho..._INT_92_95.pdf
|
Re: ZT-2 Datalogging and Uberdata help
You want the A21 pin for OBDI or the A20 for OBDII yellow/green
|
Re: ZT-2 Datalogging and Uberdata help
What do I connect the narrowband sim. and other outputs to?
|
Re: ZT-2 Datalogging and Uberdata help
Read the diagram. You hook the narrow band sim to the Primary O2 line in you car. The others you cant hook up without the add on items like EGT or Boost sensor.
|
Re: ZT-2 Datalogging and Uberdata help
Oops, sorry. So I assume when I'm done using Uberdata with my wideband I just disconnect the Wideband analog output signal with the narrowband simulated one. BTW, I remember seeing your thread on the Uberdata forums about the innacurracies of the Uberdata software with the ZT-2 kit. Has anyone figured this out yet? If so I'd love to get ahold of that script since I'm ready to tune. ;D
|
Re: ZT-2 Datalogging and Uberdata help
Bigwig messed with it, but it still is not perfect. So, I would just use the ZT2 software.
|
Re: ZT-2 Datalogging and Uberdata help
Well I re-enabled my heater circuit and closed loop with the narrowband sim. wire connected to the primary o2 sensor wire and I got a CEL. I haven't had to time to check it (will tomorrow) and I am wondering what I did wrong. I wired he 02 sensor ground wire from the wideband to a power ground on the ECU. I wried up TPS, RPM, 12v power, and its ground. Any help is greatly appreciated.
|
Re: ZT-2 Datalogging and Uberdata help
You have to cut the O2 wire completely and connect it. Not splice in.
|
All times are GMT -5. The time now is 12:16 PM. |
© 2024 MH Sub I, LLC dba Internet Brands