xenocron 2.5 bar install problem
I made my self a base map just to get it to the dyno and tune it but it wont start with a 2.5 bar installed i tied it into my stock map wires correctly using a volt meter but it wont start with the 2.5 bar installed. I unhooked the 2.5 bar and hooked up my stock map sensor and it ran fine no problems at all. I didnt try to get on it but i got up to 5 psi and it was fine but then i unhooked the stocker and hooked back up the 2.5 and it wouldnt stay on. it will start up and if i tap the gas rapidly it will jug and keep putting but wont stay on and idle.
I have it hooked to a vacuum source behind the throttle. I have tripple checked my wires and made sure that i used the install guide provided by xenocron web site. I just dont know what to do not a noob just first 2.5 bar install |
Re: xenocron 2.5 bar install problem
did you make the basemap specifically for the 2.5 bar?
|
Re: xenocron 2.5 bar install problem
yes when i went to advanced boost options it asked for the map like normal and i put in 2.5 bar
|
Re: xenocron 2.5 bar install problem
Had exact same problem with the same item. Never fixed it. :( Check out my thread a while back.
|
Re: xenocron 2.5 bar install problem
What are your settings in crome for the 2.5? Mine are...
Min 100 mbar max 2590 mbar koeov 1.89 volts Using those settings it works fine for me.My first 2.5 bar install had the exact same problem but it turned out to be wiring.Start it up it would idle high for 5-10 seconds then die.Had some wires crossed |
Re: xenocron 2.5 bar install problem
Originally Posted by imburne
Had exact same problem with the same item. Never fixed it. :( Check out my thread a while back.
|
Re: xenocron 2.5 bar install problem
i just installed mine last night following the instructions on Xenocron's site, made a new map and it started perfect
|
Re: xenocron 2.5 bar install problem
Originally Posted by ryan89crx
i just installed mine last night following the instructions on Xenocron's site, made a new map and it started perfect
like i said i used a volt meter and tripple checked the wires so what could be wrong can the map sensors go bad??? |
Re: xenocron 2.5 bar install problem
Originally Posted by tomcat
thank you. no disrespect but that doesnt help me at all.
like i said i used a volt meter and tripple checked the wires so what could be wrong can the map sensors go bad??? If you used a volt meter...what is the KOEO voltage of the signal and reference wires of the Map Sensor? |
Re: xenocron 2.5 bar install problem
Only one I've ever had "go bad" Is one I fucked up soldering,but thats on me.
|
All times are GMT -5. The time now is 06:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands