WTF with ecu chipping
 

Previously i chipped some ECU´s, but now i have a problem with one i chipped for a friend, it doesn´t work at all. Without the jumper it works as normal (duhh), but with the jumper the car limits at 45k in any gear, try different programs also those ebay JUN, Spoon chips, but have same problem.

Which could be the problem, the resistor have a side?

Note: Bought parts on an electronic store
2 0.1 UF disc capacitors
1 10 KOHM resistor (1/4 watt)
1 nte74hc373
socket, jumper and chip

Re: WTF with ecu chipping
 

usually a ---- soldering job

Re: WTF with ecu chipping
 

are you burning the chip with a 8000 offset?

Re: WTF with ecu chipping
 

Not a burning issue, I try different chips that are running and do same at 45k

Re: WTF with ecu chipping
 

thats normally a ---- solder job as chris said above. try and reheat all the joints for the 28 pin and see if that helps

Re: WTF with ecu chipping
 

Ok

Re: WTF with ecu chipping
 

If it's not a soldering problem, maybe its a desoldering problem. Check if there is no broken internal wire. I broke some on mine and I had to bypass with an external wire, but don't try this at home, i'm a professionnal :6

Re: WTF with ecu chipping
 

Maybe i overheat and burn something, that could be the problem too?.

Re: WTF with ecu chipping
 

Yep, overheat could be a problem. If you burned the board it can be worse than in my case. I was seeing where I broke wires, but when you burn a board its harder to know.

Try to follow the printed wire on the back and use a multimeter to see if all the wire have connectivity. Can be laborious, but at least you'll know what is the problem.

I should take pics of mine, I like the way I fixed it :8

Re: WTF with ecu chipping
 

i let a frind chip ecu and 3 of them dont work O0
and speaking of jun ect. programs.///chips wtf eGay ----