Wiring New Wires to ECU
 

How can I make a "pin" or somthing of the likes so I can put a wire in the A4 slot of my P28 ECU for a d16z6?

Re:Wiring New Wires to ECU
 

If you are trying to hook up vtec, it is very easy. Go to the junk yard and cut off a pin from an unused plug. Just open up the connector and pull the ---- out of it untill it comes out ( not the recommened method but it works) and then just open your ecu clip up, and slide it in. And close the latch. Solder the wire and run it to the vtec solenoid.

http://www.honda-tech.com/zerothread?id=1067906

guessing that is what you are looking for ^