spoolline

i'm gearing up to start a mega squirt conversion onto a late 70's ford 2300cc engine with mild mods which mega squirt version is best for this application i'm considering switching over to edis ignition if this help's lol i know is a newb question

ososlow

ms 2 will work just fine for you... but ms3 has more features and can datalog, the big thing about ms3 is that it can do sequential injection on v8s. ms1 will probably work but we usually just use it on fuel only applications.

3258

I would go with the MS3 for the on board data logging, sequential injection, and it also has built in coil on plug capability if needed.

ososlow

hmm i was assuming the 2300cc ford is a 4 cylinder in which case ms2 will do sequential injection just fine. but if you really want to pay double just to have data logging go for it

3258

The standard MS2 has 2 injector outputs , unless you run some extra hardware and the extra code etc, its not true sequential. I run bank to bank on my v8 through 8 low Z injector drivers on the MS2. The MS3 is worth the extra money IMO, and the datalogging is nice. For the unassembled kit, MS3=$365, MS2=$247 Check out DIYautotune.com

3258

Also note that MS3 has MAF fueling calculation capabilities, here is some more info
MegaSquirt-3 Features

AE101Jun

bringing this to life... would MS3 control VVTi?

3258

I don't think that is a standard capability of the MS3, but it seems like someone was working on a way to control that with this unit.

Some people using MS have a simple on/off switch on the VVT so it is either full on or off