VAFC
#2
Re:VAFC
Not sure if anyone here could whip up a specific diagram, but the Apexi site has a bunch of wiring diagrams that will probably tell you how to install it.
Here ya go: http://www.apexi-usa.com/documentation.asp
Here ya go: http://www.apexi-usa.com/documentation.asp
#4
Re:VAFC
Are you turboing your SiR??
Im about to install my vafc now for fine tuning the fuel, but there is a diagram on the apexi site on how to do it.. its just not listed.. get a diagram of the b16a1 pr3 output, then match to which diagram on the apexi site
Im about to install my vafc now for fine tuning the fuel, but there is a diagram on the apexi site on how to do it.. its just not listed.. get a diagram of the b16a1 pr3 output, then match to which diagram on the apexi site
#5
Re:VAFC
Look up a B16 pinout (same as PM6 except has VTEC solenoid, VTEC Oil PRessure, secondary O2, and Knock Sensor).
Then use the Apex'i manual to tell you what each wire _is_, not the color, and connect each wire to it's respective mate as dictated by the pinout, and the Apex'i instruction manual. I.E... "MAP" goes to C11.. so on so forth..
Then use the Apex'i manual to tell you what each wire _is_, not the color, and connect each wire to it's respective mate as dictated by the pinout, and the Apex'i instruction manual. I.E... "MAP" goes to C11.. so on so forth..
Thread
Thread Starter
Forum
Replies
Last Post
Slo_crx1
Engine Management
4
10-20-2005 04:40 PM