using low impendence injectors on my high impendence engine w/o resistors or box
What if i use a low impendence injectors on my 95 Civic EX engine without any resistor or resistor box? Just wanted to know what would happened? Would the car start?
|
Re:using low impendence injectors on my high impendence engine w/o resistors or
i believe it may fry the ecu injector driver.
|
Re:using low impendence injectors on my high impendence engine w/o resistors or
i dont know. however, i have tried doing the opposite of what you are saying - using 98 civic ex injectors on my 90 crx. i had them on my car for about six months until i could get the right ones, cuz my old injectors were leaking gas from the middle all over my ------- intake manifold and engine(fire hazard :P). i put them on cuz i just had them lying around. honestly, the car started fine, and i guess they worked. but... it idled like a lumpy peice of ----. surprisingly though, when racing the lumpiness went away. i always took my motor the the rev limit(7200ish rpm) and never had a problem.
but honestly if i were you i would just get the right injectors or get the resistor box. its really ------- annoying sitting at a red light and having your car sound like a stumbling piece of ----. plus its embarrassing/annoying when you got a girl in your car asking you whats up with your ride. |
Re:using low impendence injectors on my high impendence engine w/o resistors or
Out of curiousity: why wouldnt you take the WHOLE 10 MINUTES it takes to solder in the resistors in-line on your EG?
|
Re:using low impendence injectors on my high impendence engine w/o resistors or
i think he was just wondering. I really don't think he was contemplating doing it (I ------- hope not ???)
|
Re:using low impendence injectors on my high impendence engine w/o resistors or
go get some 10 ohm resistors from radioshack, they are $1.69 for 2 and they work just as good as a resistor box, they just don't look as good. all 4 of mine are just bundled together in some electrical tape and nobody but me notices them.
|
Re:using low impendence injectors on my high impendence engine w/o resistors or
mine are heat shrinked within the lil plastic dingus that bolts to the fuel rail. No one but me knows they're there.
|
Re:using low impendence injectors on my high impendence engine w/o resistors or
ya? well not everybody got the plastic dingus thing with their motor, so just chillin behind the fuel rail is where my resistors go.
|
All times are GMT -5. The time now is 05:39 PM. |
© 2024 MH Sub I, LLC dba Internet Brands