>:( urgent: TE help needed...
#1
>:( urgent: TE help needed...
Okay so I'm trying to get this burner to work and it just sin't working, it is a wellem or whatever it is
I've download the 0.97g software and im trying to use that
i removed the top jumper and set it to the At29 light and i've put the little switch board #'s 5,6, 9,11 to "on"and put the chip in 3-31 slots
now i also selected the AT29c256 (64) chip and I'm trying to erase it and the ---- isn't working , it times out all the time .
I got it to burn once, and then i put it into my car and it wouldn't start, it'd just turn over and there were no CEL's, i pulled the plugs and i have spark, and it is sprayin gas cuz i could smell it.
running NA w/ 450cc's
here is the map
http://www.sunfox.net/te/NA_450cc.bin
this is a dohc zc just running NA w/ 450cc injecotrs
I've download the 0.97g software and im trying to use that
i removed the top jumper and set it to the At29 light and i've put the little switch board #'s 5,6, 9,11 to "on"and put the chip in 3-31 slots
now i also selected the AT29c256 (64) chip and I'm trying to erase it and the ---- isn't working , it times out all the time .
I got it to burn once, and then i put it into my car and it wouldn't start, it'd just turn over and there were no CEL's, i pulled the plugs and i have spark, and it is sprayin gas cuz i could smell it.
running NA w/ 450cc's
here is the map
http://www.sunfox.net/te/NA_450cc.bin
this is a dohc zc just running NA w/ 450cc injecotrs
Thread
Thread Starter
Forum
Replies
Last Post
Jays91DXhatch
Hybrid/Tech
14
05-09-2005 08:31 PM