Uberdata idle problem
 

i've got a 96 civic, D16y7. I got a P06 and conversion harness, and 2-wire IACV to run uberdata. I did the IACV swap from http://www.hondaswap.com/forums/inde...ype=post&id=28 and it idled fine so we did a couple pulls. Now the car won't idle at all, it will just stall out. We checked the IACV and it seems to work fine, i've tried 3 diffeerent chips, but still no luck. We just can't figure out why it ran fine at first then all of a sudden it won't idle. If anyone has any idea what the problem could be or even another way to get around the 2-wire IACV w/ uberdata problem I'd really appreciate it.


Mark

Re: Uberdata idle problem
 

How is the map? Do you have a WB on it? Did you look at your spark plugs? Is it too righ at idle? You do know that the Y7 is 12btdc and not 16 right? You have to change the ignition map and get a timing light.

Re: Uberdata idle problem
 

the basemap is good, I have a wideband in, I'll have to check the plugs. the idle isn't too high, it won't idle at all, it will just bogg down and stall out, I changed the ignition map in Uberdata, I did not know that the Y7 was any different.I'll look into that. I really appreciate the feedback.

Re: Uberdata idle problem
 

The Y7 map is different. Put the timing in the idle columns I believe to the same specs as a Y8, so it would be from 16.50 to 21.50.

Also adjust your idle screw on the TB to see if that helps.

Re: Uberdata idle problem
 

thanks guys, I had no idea the y7 ignition map was different, i'm going to try that when i get home today. I really appreciate the replies, i was out of ideas.