UBERDATA ACTING WEIRD yO!
im runing a p06 91 accord f22 uber 1.66 blah blah.......
ill burn my chip the car runs great no codes nada smooth as silk and it idles great. works good under boost too. ok well everyday when i wake up to go warm up the car i get a freaking solid cel. i check for codes and the light stays solid wont blink after i put the jumper. ok so i unplug the ecu for about a minute reconnect it and still same ----. then ill uplug it, pull the chip, wait like 30 seconds, reinsert it, reconnect ecu, and the fucker runs like a champ what gives? |
Re: UBERDATA ACTING WEIRD yO!
Bad solder joint.
|
Re: UBERDATA ACTING WEIRD yO!
I had the same problem with my car, it was my mapsensor, make sure its not falling out or bare wire?mine was grounding out and causing the same ----.
|
Re: UBERDATA ACTING WEIRD yO!
weird, my gsr runs mint, i jumper it and the cel stays solid,, huh
|
Re: UBERDATA ACTING WEIRD yO!
could be a solder joint or maybe the chip just isn't making full contact with the ZIF? How long has this been going on? Anything weird with the pcb, burnt components and such?
|
Re: UBERDATA ACTING WEIRD yO!
i`d resolder all the joints
|
Re: UBERDATA ACTING WEIRD yO!
i think it has to do with the engine being cold. it wont do it even affter i get out of work. the motor is cold but i wont get a cel. ill get it only on the first warm up at 4 am when its freezing outside.
|
Re: UBERDATA ACTING WEIRD yO!
you're zif socket may have a bad contact on it, i just had this problem from using my ostrich in a zif, i messed up one of the contacts, and it was throwing a solid cel every now and then out of the blue and would run like ass. if it was the chip or the program, the cel would be on all the time! put a new zif in and make sure you have no solder crossing traces or touching another joint, and i gurantee it will be fine ;)
|
Re: UBERDATA ACTING WEIRD yO!
ok ill try it
|
All times are GMT -5. The time now is 05:36 PM. |
© 2024 MH Sub I, LLC dba Internet Brands