Hey guys does this look ok for a fuel map for 450's and 8.7 PSI?? Ive been playing with uber data hope im doin it right.. I have the boost setting at 120 and the ignition pat at 0.9%

 

why wouldn't the fuel hi tab be more important to you since in your sig it says d16z6

 

the hi fuel map would be a little more vital than lo fuel. and honestly, there's no way to tell just by looking at a fuel map if it's good or not. your curves are smooth, that's about all you can tell by looking at it, but i guarantee idle will be pig rich

 

ok hows this??

 

not gonna rev over 6500?

 

Oh i juss saw that hmm.. i have it set up under rev.. for 7500?? oh and BTW project imma still need you to do my maps im juss messing with the program..

 

as far as messing with the program and learning it. before you start messing with fuel and timing maps, just learn all of the settings under 'misc' and 'rev limits'. learn how to set them, learn how to burn chips with out getting any cel's, learn about the fuel modifiers and fuel multipliers, etc. there's no reason at all that you should be making any adjustments to the fuel maps unless you have a wide band on the car. so if you're just importing stock rom's, then the fuel map curves should look fine