Timing question (3bar at 17psi)
#1
Timing question (3bar at 17psi)
well im getting the ***** to turn the boost up on my built h22 now that i got my 3bar mapsensor
this is my 1'st attempt at making a 3bar .bin with uberdata i changed the headdings at the top of map on the boost side caus im not gonna be running anywhere near 29psi
ok my question is, i was running 20.5 deg at 11psi on my stock mapsensor tune and now at 17.6psi the timing is 16.5 deg, im woundering if thats is to much timing or not enuf.. any info would be good
thanks.
this is my 1'st attempt at making a 3bar .bin with uberdata i changed the headdings at the top of map on the boost side caus im not gonna be running anywhere near 29psi
ok my question is, i was running 20.5 deg at 11psi on my stock mapsensor tune and now at 17.6psi the timing is 16.5 deg, im woundering if thats is to much timing or not enuf.. any info would be good
thanks.
#2
Re: Timing question (3bar at 17psi)
Originally Posted by 92H22acivic
well im getting the ***** to turn the boost up on my built h22 now that i got my 3bar mapsensor
this is my 1'st attempt at making a 3bar .bin with uberdata i changed the headdings at the top of map on the boost side caus im not gonna be running anywhere near 29psi
ok my question is, i was running 20.5 deg at 11psi on my stock mapsensor tune and now at 17.6psi the timing is 16.5 deg, im woundering if thats is to much timing or not enuf.. any info would be good
thanks.
this is my 1'st attempt at making a 3bar .bin with uberdata i changed the headdings at the top of map on the boost side caus im not gonna be running anywhere near 29psi
ok my question is, i was running 20.5 deg at 11psi on my stock mapsensor tune and now at 17.6psi the timing is 16.5 deg, im woundering if thats is to much timing or not enuf.. any info would be good
thanks.
Thread
Thread Starter
Forum
Replies
Last Post
blundar
Engine Management
17
04-26-2004 03:41 PM