TE tune with O2 on or off?
So I was doing some fine tuning on the afrs in vac with the O2 off and was getting some good numbers 14.6-15.5, so I thought ok now I will turn the O2 on and it will do some smoothing out of its own and It will be tits. WRONG, one I turned the O2 in in the general options, my afrs went to ---- like 12.0-13.3!!! WTF happened? I dont get it. SO ---- it im running with the O2 off. What is the pros and cons of doing this?
|
Re: TE tune with O2 on or off?
hum?i could never get that option of t/e to work.my car was throwing o2 code only and i tried to go bacxk in and shut it off and reburn a chip but it still throw the same code.
|
Re: TE tune with O2 on or off?
Originally Posted by zccr-xsi
hum?i could never get that option of t/e to work.my car was throwing o2 code only and i tried to go bacxk in and shut it off and reburn a chip but it still throw the same code.
|
Re: TE tune with O2 on or off?
did your t/e throw an 02 code too?it even throw it with my stock pm7 so it must be my o2 going out.what would be the worst that happen if it stop working?
|
Re: TE tune with O2 on or off?
Originally Posted by zccr-xsi
did your t/e throw an 02 code too?it even throw it with my stock pm7 so it must be my o2 going out.what would be the worst that happen if it stop working?
|
Re: TE tune with O2 on or off?
i have tried trying it off but for some oidd resaon it still comes up.i went over the wiring 2-3 times.dude over on pgmfi tols me that feture didnt work.just like the check engine light settings dont work but i hear it does in bre.
|
Re: TE tune with O2 on or off?
the thing is that i get no cel because the O2 is turned off. I select it to off in boost, and the afrs go way rich. Idk whats up with that but im getting 33-35 mpg on the hwy now with the O2 off. ;D
|
Re: TE tune with O2 on or off?
tryt the perfecet pm7 bin i had nuttin but good results with tihs bin.hum>i wonder if i set it on onff in boost if it will go away?
fyi im not boosted yet! IM GOT A DOHC ZC IN THE SHOP right now being built.as sooon as it get done and broke in the motor ill post up some dyno sheet vids and tracks vid and time slips.im looking at anywhere beyteween 11.5 to 11 flat. |
Re: TE tune with O2 on or off?
W/ TE, I like to leave the o2 enabled. Unplug the o2, get the car up to temp, and do a long (8-10sec) decel in gear to trigger the o2 CEL. This way, you know for sure there is no closed loop action going on. Clean up you maps, and plug in o2 if you so desire.
This is assuming your TPS is not misadjusted, and the car is going into decel fuel cut when you try and force the O2 CEL. Good Luck w/ it. |
Re: TE tune with O2 on or off?
damn ill give that a try.i know the tps is set right.hum?ill figure it out
|
All times are GMT -5. The time now is 04:14 AM. |
© 2024 MH Sub I, LLC dba Internet Brands