still tryin to figure out chipping...
ok ...i boght a chipped pm6 for my setup ..i told the dude what i planned on doing and what i was going to run for boost in my car and ----..and he sent me two chips ....ok now i am wondering do i need anything else or will i be able to just plug in this new ecu and go...like how do i tune with the ecu?...and also what are things like when some one says there running a 2 bar or 3 bar map sensor will i need to do anything with that? these are just dumb question but..i just wanted to get a final understanding on the whole deal...
|
Re: still tryin to figure out chipping...
Well I would start reading the FAQ's in this section first, and some of the posts stickied here.
You are asking too broad of an already general question to get a good answer here that would take at least 3 days to answer. |
Re: still tryin to figure out chipping...
do i need a bar map sensor for my setup or my obd0 zc...or do i just plug in the chipped ecu i bought from you and engine tune
|
Re: still tryin to figure out chipping...
Stick with the stock map sensor until you get the hang of things and need to up the boost.
|
Re: still tryin to figure out chipping...
will my stock map hold 7 or 8 pounds some were around there...also i bought my chipped pm6 from you i think you burned everything on it i think i needed i hope ....cuz i told you what motor i had ...boost i planned running and injectors i was running
|
Re: still tryin to figure out chipping...
Read this before you ask any more questions, thanks.
https://www.homemadeturbo.com/forum/...?topic=14497.0 |
Re: still tryin to figure out chipping...
pay someone seriously this is where a turbo kit usually goes wrong
|
Re: still tryin to figure out chipping...
thats all i need thanks bro...now i get the basic idea of it...now if i wanted to do further tuning on the chip i can use the soldered in usb style and tune while running the car on my laptop?
|
All times are GMT -5. The time now is 02:30 AM. |
© 2024 MH Sub I, LLC dba Internet Brands