some more troubles
welp, i just got everything on with my d16a6, T25 stock wastegate(8psi), blah, blah. and im using the vafc with my 450'cc and all the wires are hooked up but its not changing the fuel. I have all my settings from -40 to -35 and its running so rich that i can drive 1 mile(literaly) without complety fouling out plugs :'( But when the car is running and im monitoring the screen, it says the correction is at 0. Shouldnt it show -40 at 1000? Also my engine rpms are reading 0. Any have this prob before?
|
Re:some more troubles
check your afc wiring
|
Re:some more troubles
Are you initilizing all the settings after you put them in?
If so DONT! A lot of people are making the same mistake, initilizeing erases all your settings. |
Re:some more troubles
Originally Posted by Curtis2kul
I have all my settings from -40 to -35 and its running so rich that i can drive 1 mile(literaly) without complety fouling out plugs :
got the right sensor type and car select? |
Re:some more troubles
yea, i have all the settings saved in the car. i have it set 4cylinder arrow up, 6 in 6 out wide and narrow throttle the same and i didnt change anything else one the afc. I know that it is not making the corrections because when the car is running and i go to monitor the correction rate it says 0 all the time.
By the way. My throttle reading is at .25-.30 all the time.and i know that its hooked up right because i checked the voltage at the tps and its the same. WTF |
All times are GMT -5. The time now is 12:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands