Solid cel, won't rev past 3k, WTF, please help
 

I have a socketed PM6, running 450cc, w/ turboedit. My friend made me a basemap, so I use my Motes Burn1 to burn the chip. The first time i put the chip in and start it, it actually idles pretty good. But the ECU light just stayed lit up. I gave it some gas and it would rev to about 3k (where boost starts) and the car stubbles or sounds like its on a slow rev limit. I dont know what is going on, please help. The socketed ecu just came fresh out of another running car with no problems. Im so fustrated

Re: Solid cel, won't rev past 3k, WTF, please help
 

Did you jump it and see if any codes come up?

Re: Solid cel, won't rev past 3k, WTF, please help
 

+1, i have same problem >:(

Re: Solid cel, won't rev past 3k, WTF, please help
 

Jump what? Its OBD0 ;) Its either a bad burn on the chip, chip inserted wrong, or a bad soldering job on the ecu.

Re: Solid cel, won't rev past 3k, WTF, please help
 

+1
And because that, the ECU its in Limp Mode!

Re: Solid cel, won't rev past 3k, WTF, please help
 

Wow, I musta high when I posted that. PM6, doh. :S

Re: Solid cel, won't rev past 3k, WTF, please help
 

must be limp mode, jump the service connector and tell us the code.

Re: Solid cel, won't rev past 3k, WTF, please help
 

even if it was obd1 and you could jump the service connector, a "solid" cel doesn't show any codes.......it's solid......

Re: Solid cel, won't rev past 3k, WTF, please help
 

It's a bad burn on the chip. or an incompatible base was used to make the rom.

Re: Solid cel, won't rev past 3k, WTF, please help
 

check your chip addressing. thats what happened to me. 4 weeks of messing around for 2 numbers... :-[