HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)

- Engine Management (https://www.homemadeturbo.com/engine-management-10/)

- - solid CEL problem (https://www.homemadeturbo.com/engine-management-10/solid-cel-problem-49042/)

87na_rx7

10-29-2005 07:15 PM

solid CEL problem

I just got through socketing a po6 and adding vtec to it and i just get a solid CEL. its an 011f0 board, used a 5151 switch off another p28 and the clamping diode from spot D2 on a parts board. the npn switch and 35v capacictor cam off a parts board as well. No loose solder on the board and no big puddles of solder as well. I remember from a 1980 board you remove the j4 jumper is that necessary on this board as well

tranceminister

10-29-2005 09:06 PM

Re: solid CEL problem

Some of the parts need to be installed 1 way and if they are not it won't work. Take a look at the diode etc. and make sure the + side lines up with the markings on the board and the same for the other parts.

87na_rx7

10-29-2005 09:22 PM

Re: solid CEL problem

it was a weak solder point on the small chip, what a pain in the ass to find it

tranceminister

10-29-2005 09:52 PM

Re: solid CEL problem

Yep :y, common problem but an easy fix. Glad you found it.

All times are GMT -5. The time now is 06:20 PM.