safc/injectors not working
 

i had some dsm 450 injectors i hooked up i have a turbo set up just not much boost after i hooked them up with the resistors and everything i went to start the honda civic 96....d16y8....it started and ran really rich obviously i drove 3 miles to my buddies house to install the safc and before i got there it died and wont start back up....any solutions?? we tried to hook up the safc but we must have the wrong power or the diagram we have is wrong... any help would be awesome

Re: safc/injectors not working
 

You probably flooded your engine, dumbass.

Re: safc/injectors not working
 

i am surprised it got 3 miles on 450 with nothing controlling them

Re: safc/injectors not working
 

hahah you were probably dumping SOOOO much fuel that it passed the rings, mixed with your oil and then you spun a bearing ....................bye bye motor !!!!!....


joking .....

but seriously...... 3 miles on 450's with NOTHING to control them..... I'm surpised it started.... never mind idled, or got you 3 miles...... DAMN....

good luck with the wiring ... it's not that hard.....

Lee

Re: safc/injectors not working
 

might be easier to just dump the safc and use uberdata or crome. AND have a little cash left over :y

Re: safc/injectors not working
 

You would be suprised how well a stock ecu could run them. When my buddy went to dyno his car, the tuner there started his car with the stock ecu after we installed the 550 RC injectors and after a couple seconds it idled around 11:1. That O2 correction really kicked in. The guys there did some really janky ---- though. After watching them try to tune his car, I wouldn't recommend them to someone I hated.

Re: safc/injectors not working
 

Have you got it started yet?

...heh, hopefully you didn't wash your cylinders and you can still hold compression. The extra gas will break down the oil in the cylinder and make your rings scratch up your cylinder wall (worse case scenerio, obviously). But 3 miles of fuel being dumped into your cylinders...

...geezz, you're an idiot. The S/VAFC I wiring information is in the Engine Manage FAQ. I never got around to posting the S/VAFC II.. you can get that on APEX'i's website.

Re: safc/injectors not working
 

yea i got it started it wasnt exactly 3 miles i was just guessing i got the safc hooked up right sorry that im a noob about this ----