Rough idle B16a
Did my b16a swap on my 89 ef and i'm getting a ridiculous rough idle, gas pedal down to floor and car seems to not rev up past maybe 2500k,as sson as i back off the pedal car is just sputtering and dies, on that note i'm getting code 7,8,and 21,tried new distributor but no go!! Any ideas for some solutions???
|
ok 7 is your tps sensor try swapping the 2 outer wires of your tps
8 is your tdc if you swapped a new dizzy did you reset the pcm? and 21 is vtec solenoid run vtec wiring and youll be fine your not going past 2500 is most likely your tps wires arent wires correctly so swap them around hope this helps |
I did the swap on the tps,and also what did you mean by reset the pcm? the ecu??when i put the new dist,it actually wouldn't even start put the old one back on and the thing starts but just sounds horrible it putts really low even with the throttle all the way,vtec is wired up!
|
pull your radio fuse for about 10 sec so the ecu can erase the codes and then start it up
which harness are you using |
the other day i finished a b20 swap on a del sol same kinda problem took me all day to figure it out. i had map tps and vtec code not the tdc code and it ended up being my injectors that were bad. if you have your single cam injectors and you know there good id give it a shot and swap them
|
i'm using the dx harness but with the si conversion,i do have the single cam injectors still,would they fit the b16 fuel rail???
|
yeahthey should be interchangable
|
ok ill give that a try,it might be that,but what could the tdc code be from?
|
you obd0 or obd1
if your obd1 you crank sensors actually on the crank as where obd0 its in the dizzy. when i did my single cam vtec for one of my cars and obd0 to obd1 i had the crank sensor code always but car started up fineand everything just that my obd0 block didnt have the crank sensor like newer ones do on the crank. if you look at your motor where your harmonic balancer is behing it should be a plug that comes out if its there you have a newer motor so dont really stress on it if your obd0 if your obd1 you need to plug that in so the mil goes away |
i'm running obd0,but i cant find my other obd0 injector clips!
|
All times are GMT -5. The time now is 06:26 AM. |
© 2024 MH Sub I, LLC dba Internet Brands