Ran in to a problem with the LC1 and O meter setup.
 

I finally wired everything up and the LC1 did its calibration for the first time. The status light is solid so I know the LC1 works. I hooked up the Ometer as per directions, Ground, Positive and Analog2 0-5v (brown) from the LC1.

The problem is when I turn on the car the O meter just counts down from 18:1 to 11:1 and stays there. I get no AFR reading. I can get on the gas and its still sitting at 11:1. what could be causing this problem? I would really like some help here.

Re: Ran in to a problem with the LC1 and O meter setup.
 

Have you looked at the output of the LC-1 in logworks... Need to determine if the calibration is off or if it's another issue.
The LC-1 can be setup for different output ranges.

Re: Ran in to a problem with the LC1 and O meter setup.
 

To be honest with you I havent even hooked it up to Logworks yet. Going to today or tomorrow hopefully. I thought that it should give me some readings if I just plug and play. But I'll check it out.