Quick question for LM-1 users
 

Which analog output is which? The manual clearly states analog out 1 is narrowband, analog 2 is wideband. Ok, sounds good. BUT IT DOESN'T TELL WHICH WIRE IS WHICH! One is white, one is red. The manual gives all the info I need except this. Who knows which is which?

Re: Quick question for LM-1 users
 

I'm pretty sure I remember tell colors.

Look on their site, or even easier...hook up a volt meter and see how much voltage each wire is outputting to tell for sure.

Re: Quick question for LM-1 users
 

I just got my lm-1 last week i dont even know what the hell that wire is for can some one tell me and where to hook the 3 wires to????? thanks alot

Re: Quick question for LM-1 users
 

anyone????????

Re: Quick question for LM-1 users
 

Someone told me it's the red wire for wb, white for nb

Re: Quick question for LM-1 users
 

I use the red wire for mine.

Re: Quick question for LM-1 users
 

In the Honda tuning mag two months ago it said to hook up the Red for hooking it up to your ecu d14

Re: Quick question for LM-1 users
 

Well I just found out that the white wire is analog ouput 1, and the red wire is analog output 2. By the default settings that means that red=narrowband and white=wideband. So this whole time I have been trying to datalog a narrowband signal! I'll switch to the white wire and hopefully it will work perfect now ;)

Re: Quick question for LM-1 users
 

Did you set up the outputs using the Innovate LogWorks software (or whatever it is called now)?

Re: Quick question for LM-1 users
 

I set them to the defaults through that, yea. I figure since Uberdata has a special configuration for the Innovate WB that it must be calibrated for the default settings through logworks, or it would totally defeat the purpose of having a setting for the Innovate, right?