quick inline resistor install ?
 

Hey everyone i just bought some 10 watt 10 ohm inline resitors and im installing them on my obd1 civic for my 450's. I just run them inline on the yellow wire with the black stripe coming off of the injector right and leave the other wire alone. Is this correct? I think so but just want to make sure! Also do I need to grind down the little bump in the inside of my 450 to make it fit in my obd1 clips?

Re:quick inline resistor install ?
 

anyone???

Re:quick inline resistor install ?
 

yeah i wanna know too..haha. seriously though i know u can run the resitor pack, but since i already have the 10w 10ohm resistors, i also wanna run them inline. could i just use the stock dsm clips? or i gotta use the obd 1 clips that are in my civic now? and pics or diagram would be helpful..thanks

Re:quick inline resistor install ?
 

yah i know you can just grind that little notch down inside the injector and then they will fit into obd1 car clips ill get a pic of it later but I still need to know if I should put the resistors inline on the yellow wire with the black stripe and then leave the other one alone. Cmon all these people runs 450's and no one knows the answer? ;D

Re:quick inline resistor install ?
 

yeah bump this...

Re:quick inline resistor install ?
 

you got the right idea buddy...start cutting wires

Re:quick inline resistor install ?
 

dsm clips or my stock obd1 clips?

Re:quick inline resistor install ?
 

either shave off the little ridge inside the injector or use the dsm clips

Re:quick inline resistor install ?
 

thanks man! that was a lifesaver.

Re:quick inline resistor install ?
 

ok.. this has been a confusing topic for myself for sometime now.

4g (88-91) civics/crx's use peak & hold. the ecu is expecting to see the same resistance as stock injectors so you retain the injector box.

but 5g and newer use saturated injectors. with no resistor box from the factory. why do we need to add a resistor to the dsm injectors if the stock ones don't?