Problems w/p30 basemap in crome
 

HI,
I am running an Ls/Vtec setup w/ a chipped po6/chipped for vtec. Whenever I try to run a P30 basemap, my ignition breaks up and the car bogs when Vtec is engaged. I have Knock sensor,O2 sensor diabled as well as atmospheric pressure sensor in Crome V1.2. When I run P28 code, everything runs great. Any suggestions?

Re: Problems w/p30 basemap in crome
 

Run the P72 bin.

Re: Problems w/p30 basemap in crome
 

did you disable knock sensor in p30 code?

Re: Problems w/p30 basemap in crome
 

yes, I disabled the knock sensor. Its really wierd, I am using a totally stock P30 map, and as soon as it switches to high cam, I get all sorts of studdering and a dramatic loss of power.
P72 seems to work fine, do I just set the IAB RPM setting to something rediculously high value to disable them? (don't have them).
Is there any real big difference between the P72 and P30? If not, I really don't care, I am really new to tuning anyways. I just thought it was really odd that P30 hates me so bad, I guess nobody else has had this problem.

Re: Problems w/p30 basemap in crome
 

I use p30 for everything and have never ran into any problems



besides some minor ignition changes your not in any danager

Re: Problems w/p30 basemap in crome
 

I just got my wideband running properly and even with the P72 map I was running really,really lean (>17.5:1). So I added a ton of fuel to the map and got the afrs down to around a little below stoich. Maybe i'll try to add fuel to the P30 to see if the misfire goes away. Its just wierd that the P28 would run good, i thought the fuel maps would be far less agressive. :( ???

Re: Problems w/p30 basemap in crome
 

Use the fuel multiplier to compensate for the added displacement. LS displacement on P30 code will require at least 15% more fuel.

Re: Problems w/p30 basemap in crome
 

Yeah, I should have thought of that.. :-[
I forgot to mention cylinders are also bored .020" over, so theres even more displacement..