Post your AFC/SMC Settings here!
Ok, lots of guys just love asking this question, so lets get a thread going of people who have AFC controllers, w/ (whatever injectors)
Just post your basic setup, and each percentage, at each rpm incriment. Also post your SMC + Controller settings! Jeff Frank |
Re:Post your AFC Settings here!
D16z6
dsm 450cc APEXi Vafc t3 .63/.42 modified starion intercooler 7.5psi 1k -25% 2k -40% 3k-40% 4K-39% 5K-38% 6k-37% Timing is retarted about 3deg. |
Re:Post your AFC Settings here!
Idle a bit messed up, having to bog it with fuel, omahaturbocivic?
I've run, in the past: 1K: -25% to -27% (idle problem) 2K: -38% 3K: -37% 4K-5K: -36% 6K-8K: -35% 89 CRX 94 B18B (I use OBD0 ECU) Saab .42 trim/.48AR turbo non-IC I got a little creative and set my TPS switching points so that fuel was a little leaner under part throttle. As you get familiar with your setup, you can figure out how to do that on your own, I don't think there are any general rule of thumb settings for that. I've fiddled my idle pulsewidth and fuel maps a bit, my current settings, which won't work for you unless you have an LS and the .bin running my ECU, are: 1K: -40% 2K: -38% 3K: -39% 4K-6K: -39% 7-8K -38% Basically, I fixed my idle injector pulsewidth to like the 450cc injectors, and put a little fuel in the boost/upper rpm maps. I could get it -40% across and running perfectly, but, ah, I'm a lazy bitch? |
Re:Post your AFC Settings here!
this is what im using now and ive had the boost up to 12psi and it seems to stay steady....
hi*** low**** 1000 -39 -45 2000 -39 -43 3000 -38 -38 4000 -37 -37 5000 -36 -36 6000 -36 -36 7000 -36 -36 7500 -36 -36 im currently only running 8psi with the same settings since is still want this motor to last more than a month at least . t3,450cc, walbro pump, d16a6, with 200,000 plus miles! |
Re:Post your AFC Settings here!
Originally Posted by Joseph Davis
Idle a bit messed up, having to bog it with fuel, omahaturbocivic?
I found I get the most consistent idle at -25%. At -40% or really anywhere else it idles the exact same but about every 30 sec or so it would stumble in rpms a for a sec then idle fine for another 30 sec. I posted the problem on honda tech and it turns out a lot of people run -25% on idle. It does not idle that rich I believe because if you move the idle around while the engine is running it will run diff for about one second then the ecu corrects and it idles the same. |
Re:Post your AFC/SMC Settings here!
o.k. I don't know if any of you guys have seen this on this site where the guy tells you how to tune a V-AFC and using a MSD BTM and he's running 10psi and no check valve's. Are his setting the same with a AFC as a V-AFC and all you have to do is not set the high and low cam's. or is it different fuel settings for a DOHC Vtec motor then a non-Vtec motor. Here's the site and the article is under the tech. section I think.
www.thedropshop.com |
Re:Post your AFC/SMC Settings here!
i did my friends 99 si. b16a drag gen 3 kit t3/t04, 550cc msd high impedance injectors, vafc hack, 10psi spikes to 13psi.
***low and high*** 1k -40% 1.5k-4.5k -35% 5k -30% 6k-8.2k -30% vtec 5.5k low to high vtec 5.4 high to low soon to install the inline pump by drag. |
Re:Post your AFC/SMC Settings here!
Bone Stock D16Z6 with a short ram...
I feel a very good pull on it, someone who has the same setup and a air fuel guage test it and see if its running lean or rich.. The car feels good when i ran it but im not sure if its a safe setting. Wide Throttle: Lo cam Hi cam RPM Fuel % RPM Fuel % 1000 0% 4000 -7% 1600 -4% 4400 -7% 2200 -7% 4800 -8% 2800 -7% 5200 -8% 3400 -7% 5600 -8% 4000 -7% 6000 -7% 4600 -6% 7000 -6% 5000 0% 8000 -4% Narrow Throttle: Lo cam Hi cam RPM Fuel % RPM Fuel % 1000 -4% 4000 -1% 1600 -6% 4400 -2% 2200 -6% 4800 -3% 2800 -6% 5200 -3% 3400 -6% 5600 -3% 4000 -6% 6000 -3% 4600 -6% 7000 -1% 5000 0% 8000 0% VTEC engagement point: Lo cam – Hi cam 5000 Hi cam – Lo cam 4800 NE Point: Lo cam Hi cam NE1 1000 NE1 4000 NE2 1600 NE2 4400 NE3 2200 NE3 4800 NE4 2800 NE4 5200 NE5 3400 NE5 5600 NE6 4000 NE6 6000 NE7 4600 NE7 7000 NE8 5000 NE8 8000 |
Re:Post your AFC/SMC Settings here!
Please dont ask questions in this thread,
thanks |
Re:Post your AFC/SMC Settings here!
93 civic hatch
smc plus 450 dsm injectors idle -35% 1k -38% 2k -37% 3k -36% 4k -35% 5k -34% 6k -32% 7k -30% 8k -30% 9-10psi |
All times are GMT -5. The time now is 05:53 AM. |
© 2024 MH Sub I, LLC dba Internet Brands