obd-o ecu chipping
I have a 91 integra i am turboing, my ecu is already socketed from a cheap ebay chip i installed ( and since uninstalled). can i just get a new chip for my eng/mgmt or is there more involved. running a t3 450's 6-8 psi. was planning on running a fmu, but if this crom or uberdata stuff is easier( i know its better than a fmu)i'd like to go that route..thnx I'm in GA by the way
|
Re: obd-o ecu chipping
obdo only free editor that is proven to work on non vtec code is turboedit. All you listed are obd1
|
Re: obd-o ecu chipping
ok thanks, but how do i go about getting this. i did find the turboedit.org site, buti'm not really sure about how to use it. what all do i need.
|
Re: obd-o ecu chipping
You need a wideband O2 sensor and a chip burner or a Ostrich for real time programming.Go to www.pgmfi.org and start reading.You can get all your ecu/tuning gear from http://www.-------------/
|
Re: obd-o ecu chipping
thanks for the info
|
Re: obd-o ecu chipping
where in ga are you?
|
Re: obd-o ecu chipping
it wont be quite as cheap as just slapping a fmu on, but it will be about 100 times better, read up on pgmfi.org and for parts xencron.com(spelling)
|
All times are GMT -5. The time now is 06:15 PM. |
© 2024 MH Sub I, LLC dba Internet Brands