obd-0 ecu help
 

I have a B16a in my 89 civic..I just put a turbo kit on it but have no fuel management for the car yet..Any and all suggestions and help would be appreciated..would prefer to stick with the PR3 ecu if possible..Let me know..thanks..

contact Matt @ wickedinnovation.com... Tell him Devon in Fl. sent ya. He's got great turbo maps for you.

*tom NOT matt... sry!

sorry to thread jack... but i have the same problem... i was going to swap to obd1, but if i can stick with the pw0 ecu i would be so incredibly happy. i think the conversion to obd1 might be a bit of a headache. the only problem is that i dont thin kyou can tune obd0... and if you can, i believe it is extremely difficult.

thanks for info..I'll drop him a line..

not a prob. man... he put a pm7 basemap on my pm6 ecu not too long ago, and i love it!!! Especially the launch control!! Im havin him tune it again when i get finished with my turbo build.

help
 

what do you all think would be the best tune to put on an obd-0 PR3 ecu..running 440 dsm injectors, and 8psi..also do I need to cahnge out the map sensor or put any check valvesin to block pressure to it?? thanks for any help I get..car is all together I just need the tune to get it on the road..driving it around short shifting sucks..haha

you can solder you obd0 ecu for an eeprom.
you can use bre or turbo edit for tuning this ecu chip.
you can find basemaps all over the internet. start from there.

i sound like dr phil.... YOU YOU YOU!
annoying...