Need some quick help with basemap
 

RSmotors tune ZC.bin
dohc ZC dyno tuned up to 11.5 psi 208hp/171trq .48/.60 T-bird 450's motorola 2.5
http://www.-------------/bins/index.p...rectory=Crome&


About to start the pig finally... My setup is similar to this basemap but I'm using the stock honda MAP sensor (running 9psi) Is this going to be a problem and can I change it in crome? I have a burner ready to go but the program is still a little foreign to me

Also awhile back I disabled my IACV by opening the .bin with a hex editor. I searched and replaced two values to force the ecu to ignore it, but I forget what values are to be changed. If anyone knows what I'm talking about let me know in the meantime I'll look on the pgmfi.org boards

Re: Need some quick help with basemap
 

If it's anything like BRE you're going to have to re-tune to the lower boost level the stock map sensor sees. In BRE when you go from a 2.5bar map to a stock map it takes all the values that were originally tuned in the 2.5bar setup and squeezes those same values down to a lower range.