Need some help with integrating the LC-1, P75, Crome and an external display
 

I have an LC-1, brand spanking new from Xenocron. I bought one of these -

http://cgi.ebay.com/ws/eBayISAPI.dll...MEWN%3AIT&rd=1

I am going to use one of the outputs on the LC-1 to give off a 1-2 volt referenece, so this can display my a/f ratio.

The second output is going to be my P75, as I want to be able to integrate this into crome. I'm assuming that this is what I want to do, seeing as how I'll be using Crome to make all my changes. Should I do this, or should I just run logworks and be done with it? What do you guys do?

My 2nd problem is this - The LC-1 has 3.5mm headphone plugs for the outputs. I have a 3.5mm to serial cable that came with the LC-1 that I could use to run logworks. How would I integrate these outputs to the P75, as well as the digital display? I know there are three small wires in these cables. I split a wire open and saw there was a red, a white and a green wire. Which of these do I need to use? If anyone could clear this up, that'd be awesome. Thanks guys.

Colin

Re: Need some help with integrating the LC-1, P75, Crome and an external display
 

The LC-1 is also wired with outputs. You Don't use the stereo plugs to output to your ecu. Only to the serial cable. Its all in the directions.

Re: Need some help with integrating the LC-1, P75, Crome and an external display
 

That was ------- stupid of me. thanks.

Re: Need some help with integrating the LC-1, P75, Crome and an external display
 

Log through the ECU using the free software out there unless you are usnig Crome Pro then use that. Logworks is kinda pointless unless you have one ot their input boxes.

Re: Need some help with integrating the LC-1, P75, Crome and an external display
 

I'm just going for CromePro. I want this to be as easy as possible. Thanks.