I don't have a burner and but I have my p06 socketed to be chipped. I was wondering if someone could burn me a chip for OBD1 and running 8-7psi. I'm looking to use stock 240 injectors since I don't feel like wiring up a resistor box, but I looking for bigger injectors to use with the high impendance setup.

 

You aren't going to be able to run more than about 2-3 psi roughly with stock injectors, if even that. The injectors will reach maximum duty cycle somwhere around there. Just buy some DSM 450's and a resistor box. There are great instructions on how to install these and its not too hard anyways. There are lots of people willing to help and point you in the right direction.

 

Well my chipping project didn't turnout good and I must of shocked the chip of got the board cause it only revs to 4k so now it's junk pretty much unless I can get a new chip and see if that was just it. Could someone hook me up with that? Something like a mugen program or spoon or sometype of ---- like that? I hate to toss a ecu if just the chip is bad. GOod thing I got the ecu for free and the ebay chip for 13 bucks. I'll pay someone for a chip. Also does anyone know if the rx7 injectors would work being that there saturated? I believe their like 460 for the NA ones?

 

Cut the jumper on the ecu to return it to stock and see if everything works fine. That will tell you if the ecu is good or bad.

 

also did you set a revlimiter on the chip that was burnt. chrome ect for obd1 has a rev limiter that if the car isnt moving then it will only rev to a certian rpm.