NEED HELP, need to replace jumper J12 - Getting code 13
What resistance is Jumper j12? I need to put it back in, I put my stock injectors back in and running stock map but cel comes on (prolly because i pulled j12). If you could just check the color code and post it up for me, it would be a big help thanks!!!
|
Re: NEED HELP, need to replace jumper J12
Jumpers are 0 ohm. Use a piece of wire. Your problem is not related to J12. That jumper just connects the Rx and Tx lines of the serial communication. |
Re: NEED HELP, need to replace jumper J12
Then I dont understand why i'm getting a CEL? Its running stock injectors on the stock map, and I took the resistors out.
|
Re: NEED HELP, need to replace jumper J12
check the code
btw does the j12 hav to b cut if a nokia usb cable is installed for datalogging? |
Re: NEED HELP, need to replace jumper J12
depends on the rom editor.
|
Re: NEED HELP, need to replace jumper J12
Ok, I just got home from a hard weekend of drinking, I spent an hour at a carwash tonight @ 2:00 AM because some peice of ---- puked all over inside/outside my car. Anyway, I'll check the code in the morning and get back.
Originally Posted by CSaddict
depends on the rom editor.
I was doing some reading about J12 and when you cut it, it seperates the Tx and Rx so your ecu can send and recieve signals through seperate lines (full-duplex) instead of through one (half-duplex) |
Re: NEED HELP, need to replace jumper J12
Ok i'm getting a code 13
13. BARO Sensor (Atmospheric Pressure) defective circuit or unplugged / defective sensor where is the BARO sensor? i'm pretty sure i've never unplugged any sensors but if you know what the problem could be your help would be appreciated. |
All times are GMT -5. The time now is 10:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands