Sup, I just found some injectors off a 89 mazda Mx6 turbo. I was wondering if this could work on our cars. They look like the could fit in the manifold without any problem. I have searched and came up with that they are 310cc injectors high impendence. You guys think this could work on 8psi boost setup up that I am gonna do on my car. I have a d16z motor (cheesy tec , like I call it :-).
thanks

 

I'm running the 2.2l ford probe turbo injectors, which are 310cc. I hear they used the same setup.

Nick

 

probes have the same F2t motor as the MX6. The 91-92 injectors are 330cc. I've got a set I'm gonna use that are flow ported and cleaned by RC for a 10% increase to around 350-360. That's what I'm planning for my D15 turbo setup... should be fun.

 

I was trying to find some dsm 450 injectors but all the ones I found at a local junkyard were not turbo, and the one that I found had not injectors on it. I was a little late :-). Does anybody know where I can get this tested and probably flow ported like jung4g said one the east coast?
I will search other junkyards for the 450, or I will buy them from ebay. I just have to make my mind. But for what I have searched this 310 injectors should be fine for our setup, plus a vafc hack with it and no resistor box.
Later

 

so you dont need to run a resistor box when you put turbo ford probe injectors into youe honda? can all hondas do that (civic accord and ect.)?