mpfi problems
#1
mpfi problems
Ok i did a mpfi/z6 swap on my 88 crx dx.I got everything correct but im getting a tdc code(code and a code 10.Im not getting spark.But i am getting fuel.I double checked my wires.everything appers correct.So any help would be great.Thanks
#2
Re: mpfi problems
Code 10 is the intake air temp sensor i believe. I pretty sure i had that same code on my buddys car when i did his swap. I just had the wrong plug plugged into that sensor :P. So check that. The air temp sensor is on the drivers side of the intake, its white. If you had an extra two wire plug left over not plugged into anything swap it with the one you have plugged into the sensor now.
#4
Re: mpfi problems
ok i checked the wiring and its all good.But im not getting spark.I hooked a dowed machine to it said my igniter was bad.replaced tested again and nothen now.i need some help i need this thing to run before the end of the week.
Thread
Thread Starter
Forum
Replies
Last Post
idiot-stick
Engine Management
7
03-18-2005 06:21 PM
davcivic
Hybrid/Tech
11
01-11-2005 06:36 PM