mpfi problems
 

Ok i did a mpfi/z6 swap on my 88 crx dx.I got everything correct but im getting a tdc code(code 8) and a code 10.Im not getting spark.But i am getting fuel.I double checked my wires.everything appers correct.So any help would be great.Thanks

Re: mpfi problems
 

Code 10 is the intake air temp sensor i believe. I pretty sure i had that same code on my buddys car when i did his swap. I just had the wrong plug plugged into that sensor :P. So check that. The air temp sensor is on the drivers side of the intake, its white. If you had an extra two wire plug left over not plugged into anything swap it with the one you have plugged into the sensor now.

Re: mpfi problems
 

i did swap plugs but still not going off.im about to switch sensors now

Re: mpfi problems
 

ok i checked the wiring and its all good.But im not getting spark.I hooked a dowed machine to it said my igniter was bad.replaced tested again and nothen now.i need some help i need this thing to run before the end of the week.

Re: mpfi problems
 

Are you positive that all your wiring is correct. Check all the wires for the distributor. Make sure you didnt get your C1 and C2 wires mixed up

Re: mpfi problems
 

ok i did that c1 and c2 are right were they are supposed to be.

Re: mpfi problems
 

i put in a brand new coil.Still no spark.COuld it be a igniter????That what it all comes down to.I am really getting pissed i dont knwo what else to do??