Ok, so i bought a moates chip burner to start tuning my P28~

I bought 10 chips off of xenorcron, the chips are the same as the basemap chip in my ECU: BUT, the chips only have 28 prongs... the Burner has 32.~

I'm not sure how the chip is supposed to fit in this burner~ Can it go into any of the prong holes? Do you understand what i mean? i can put the chip into the burner 3 ways~ To the left, w/ 4 holes on one side, Or in the middle with 2 prongs on both sides, or The other side...

Also, which way should the chip sit? should the Letters on the chip be right side up with the Burner's Lever on the right? or other way around?

14
16

 

do the chips have an arrow on them? some chips have like a half circle on them, make that point to the usb end. place the chip towards the back of it(the front being where the lil jumper thing is)

 

Here is a better pic from moates site.. Got mine last night, after xenocron explained the addressing offset thing I got my first chip to work.

 

good pics!

 

haha, yea. my pics are shitty as hell. it was at night and the lights were off, i didnt really care.

but yea, I just did trial and error until it worked(took me 2 tries).