Map cel during boost Prob.
I have a zc with 8 lbs goin to it and i keep getting map cels. I have 450ccs and an smc 500. My settings are:
1000 38% 2000 38% 3000 38% 4000 37% 5000 37% 6000 36% 7200 36% When at WOT i throw a map cel at 6000 at 8 pounds. It seems to be running rich as ---- by the looks of the plugs. What should i do. WHy does the map cel keep on coming on with such low boost with the smc? Later Pete, |
Re:Map cel during boost Prob.
you need to set the map voltage clamp with a voltmeter...look in the smc instructions
|
Re:Map cel during boost Prob.
So you dont need a missing link with an AFC?
|
Re:Map cel during boost Prob.
hes using an smc not an afc...which i dont know jack ---- about, but ill say no
|
Re:Map cel during boost Prob.
SMC is about the same ----. Check your voltage clamp. Then CHECK YOUR WIRING. This was my biggest flaw. Make sure all wires are connected and have a secure connection. And DONT USE WIRE TAPS. Strip the wire and solder it on. Those taps fucked me all up. ::)
|
Re:Map cel during boost Prob.
i played with the voltage clamp at 3 volts and it came on once after like 10 Wot runs. little more tuning and it will be gravey.
|
Re:Map cel during boost Prob.
Check what CEL it was. It might be the ol honda ecu boost limit.
|
Re:Map cel during boost Prob.
i turned my voltage clamp pretty much all the way up
|
All times are GMT -5. The time now is 10:10 AM. |
© 2024 MH Sub I, LLC dba Internet Brands