Loading p28 map, yes i know HOW to do it....
 

Well, i know to load up teh stockGSR bin, but when i go to import the p28 bin, nothing changes, did i miss something, using the latest uberdata out, and i import the stockEX bin, and nothing changes.... vtec still activates at 4300 and the maps dont change... Any tips...

Re:Loading p28 map, yes i know HOW to do it....
 

close down uberdata.

reopen it
open up the gsr bin
import the p28 bin
click to a different tab and then click back to the tab that it opened onto.. It should be different.
Uberdata has problems of refreshing sometimes.

I hope this helps

Re:Loading p28 map, yes i know HOW to do it....
 

Oh, well this time the low fuel tables changed, but the rev limits tab and misc are still the same. Hmmm, well, at least the tables changed....

Re:Loading p28 map, yes i know HOW to do it....
 

i dont think the other tabs will change much. Just make sure the fuel and ign maps are the ones that changed. Also make note that the p28 doesnt have a knock sensor so you can just disable it.

Re:Loading p28 map, yes i know HOW to do it....
 

Very true, but i have a y8 in there now, which has a knock sensor, would it be worth my while to try to use it? If so,whcih pin on the ecu would it hook to?

Re:Loading p28 map, yes i know HOW to do it....
 

You want D3 for knock wire. go here http://www.turbod16.com/viewtopic.php?t=3572

Third diagram down.

Re:Loading p28 map, yes i know HOW to do it....
 

p28 doesnt have a knock board. No KS for you ;)
Assuming your on a P28.

Re:Loading p28 map, yes i know HOW to do it....
 

ah, shitty, if i were to use it though, i gues i would have to run a gsr ecu then right? To much hassle, lol...

Re:Loading p28 map, yes i know HOW to do it....
 

i tend to have problems loading my own bin's into uberdata.... i open stock gsr, import p28, then i import my personal bin... but once i do that, everything goes to hell. my fuel maps go off the charts (like a 1000% duty cycle)... its very odd.

any ideas?