LC-1 to replace narrowband?
what values to i need to reprogram it to? i'm still getting a CEL. i connected it to the D14(i think, white wire). i couldnt find ---- on google. thanks for any help
|
Re: LC-1 to replace narrowband?
IIRC it's one of the analogue outputs that need to be programmed as 0-1v narrowband.
|
Re: LC-1 to replace narrowband?
ok, thats what i needed to know. i couldn't find the voltage values anywhere.
is that 1v at 15 or so afr? |
Re: LC-1 to replace narrowband?
yeah, that's what I have written down on a scrap of paper from when I set up a buddies LC1.
|
Re: LC-1 to replace narrowband?
like .18 at air, 1v at fuel. afr is in the middle
|
Re: LC-1 to replace narrowband?
Originally Posted by c0mpl3x
like .18 at air, 1v at fuel. afr is in the middle
|
Re: LC-1 to replace narrowband?
Originally Posted by MAJORAHOLE
???
how does setting stoich, which is like .45v on a narrow, at 1v on a 0-1v scale, work? |
Re: LC-1 to replace narrowband?
im just tryin to figure out what i should set it at
so 0 on the lean side and 1v on the rich side? |
Re: LC-1 to replace narrowband?
Originally Posted by MAJORAHOLE
im just tryin to figure out what i should set it at
so 0 on the lean side and 1v on the rich side? |
Re: LC-1 to replace narrowband?
lc-1 manual claims their Analog Out 1 is already programmed from the factory to narrow band specs. It shows 1.100Volt at Lambda: 0.958 and 0.103 Volt at Lambda: 1.022
|
Re: LC-1 to replace narrowband?
i tried it at their oem spec, and i still got an 02 cel.
hmmm, i guess ill check pgmfi |
Re: LC-1 to replace narrowband?
are you throwing an error for incorrect voltage, or is the ecu seeing a fuckup in the O2 heater circuit? I don't know if honda's have a code for that but my dd just threw that one.
|
Re: LC-1 to replace narrowband?
iirc it was the cell for the heater deal, so that has nothing to do with my prob?
i didnt think there was a different code for the voltage input |
Re: LC-1 to replace narrowband?
Originally Posted by MAJORAHOLE
iirc it was the cell for the heater deal, so that has nothing to do with my prob?
i didnt think there was a different code for the voltage input Personally I just used Innovates stock NB voltage curve and disabled the O2 heater code in the ROM when I was running my LC1 full time. |
All times are GMT -5. The time now is 04:08 PM. |
© 2024 MH Sub I, LLC dba Internet Brands